End of previous process

• It is not necessary to change the molding temperature of preceding resin if the right temperature range for Z CLEAN is kept.

Z CLEAN charge, cleaning, and replacement

• Continue cleaning until the color of preceding resin changes to the milky white.

Stop machine, filling the cylinder with Z CLEAN

• In order to prevent oxygen from entering the cylinder, do not let inside the hopper become empty of Z CLEAN while the machine is suspended.

Turn off heater power

Day off seal

Turn on heater power

Purge out Z CLEAN from cylinder

• Take preheating time similar to usual molding before turning heater power on.

Succeeding resin charge

• Set the suitable temperature for succeeding resin.

Replace succeeding resin

• Replace Z CLEAN with succeeding resin.

Check the molded form

Start of following process